EPS400 Foiled Panels
EPS400 Foiled Panels
£22.50£27.00 Ex. VATInc. VAT
Our Rapid Response underfloor heating EPS400 overlay boards are lightweight, super strong, easy to fit, and designed to be laid over any existing or new floor. The aluminium covering provides optimum system performance and is perfect for both commercial and residential use.
Features:
- Lightweight, super strong EPS400 overlay boards.
- Suitable for use under laminate, engineered wood, carpet, vinyl, and tiles.
- Can be laid over any existing or new floor.
- Perfect for both commercial & residential use
- Minimal height increases of just 20mm or 16mm.
- High compressive strength of 400KPA
- Each panel measures 1200x600x20mm or 1200x600x16mm
- Takes 16mm or 12mm pipe at 150mm pipe spacings.
- Pre-formed with straight runs, return loops, and cross runs at one end.
- Covered with a layer of aluminium, spreading heat quickly & evenly across the surface to maximize the output and efficiency of the system.
- Perfect choice for retrofit installations.
Installation:
The panels are laid directly onto the existing concrete, floorboards, or solid flooring.
Fix securely using Rapid Response Spray Adhesive or Mapei eco 380.
Adhesive Consumption Rate:
Wood/tiled subfloor – 5sqm/can: Spray only the subfloor then lay the board onto the glue.
Concrete/porous subfloor – 2.5sqm/can: Spray the subfloor AND the underside of the board so you are putting glue to glue.
Flooring Advice:
Laminate/Engineered Wood:
Lay flooring directly onto the EPS floor panel as a floating floor.
If no underlay is pre-bonded to the underside of the planks, use our 3mm breathable underlay before laying the floorboards.
Do not exceed 20mm board depth!
Carpet/Vinyl:
Prime the surface of the EPS board using Ultra Floor prime it, then cover with 5-6mm fibre reinforced self-levelling screed. We recommend Ultra Floor Level it Two
Ensure the board and channels are fully and evenly covered for a smooth, level finish.
Carpet & underlay combined should not exceed 2.5tog.
Tile/Stone:
Prime the board surface using Ultra Floor prime it, then cover with a 5-6mm self-levelling screed. We recommend Ultra Floor Level it Two
Tile directly onto the screed using Ultra ProFlex S2 Flexible Tile Adhesive.
Ensure using a highly deformable flexible S2 tile adhesive.
Do not exceed 20mm tile depth- ideally 15mm or less!
Maximum Pipe Length:
20mm panel = 100m
Installation Video
